Filter
Top Products
Section 4: Maintenance and Troubleshooting
4-6 RPMX/CX50/CX60/CX67 User’s Manual
Figure 4.3.
(b) Firmly, grasp the lamp module and pull straight out. Keep the lamp level
when doing this so that it easily disconnects from the terminal block.
(Figure 4.4.)
Figure 4.4.
STEP 4 – Install a new lamp
(a) Slide the new lamp into the lamp module so it fully connects into the
terminal block.
(b) Turn the lock ring to the LOCK position.
STEP 5 – Close lamp door and record new lamp serial number
(a) Swing the lamp door up and re-tighten the 2 screws loosened in Step 2.
(b) Plug the projector back into the AC outlet and power it up to continue with
operation.
(c) Reset lamp hours and enter a new serial number, using the serial command
LPC. For example: (LPC AAAA123456789) NOTE: You can enter a serial
number up to 13 characters (maximum).
See also, 3.4 The Lamp Menu in Section 3.