Filter
Top Products
Appendix B: Signal Types
B-2 RPMX/CX50/CX60/CX67 User’s Manual
Format Type Mode H.
Freq
V.
Freq
Input
Resolution
Sync
polarity
Scan Type Input
Terminal
VESA 800X600 @85Hz SVGA85 53.674 85.061 800X600 P/P Non-Interlaced RGB IN
MacIntosh 16inch Mode @75Hz MAC16 49.725 74.550 832X624 -/- Non-Interlaced RGB IN
VESA 1024X768 @43Hz XGA43 35.522 43.479 1024X768 P/P Interlaced RGB IN
VESA 1024X768 @60Hz XGA60 48.363 60.004 1024X768 N/N Non-Interlaced RGB IN
VESA 1024X768 @70Hz XGA70 56.476 70.069 1024X768 N/N Non-Interlaced RGB IN
VESA 1024X768 @75Hz XGA75 60.023 75.029 1024X768 P/P Non-Interlaced RGB IN
VESA 1024X768 @85Hz XGA85 68.677 84.997 1024X768 N/N Non-Interlaced RGB IN
MacIntosh 19 Inch Mode@75Hz MAC19 60.135 74.700 1024X768 N/N Non-Interlaced RGB IN
WK Std 1280X1024 @60Hz SXGA 64.00 60.000 1280X1024 N/N Non-Interlaced RGB IN
1028X1024 @75Hz SXGA 79.976 75.025 1280X1024 P/P Non-Interlaced RGB IN
Note 1: In composite sync or sync-on-green signal, H sync signal must be inserted into V sync signal.
Not Good GoodNot Good Good
Note 2: In H/V separation sync signal, V sync signal must not include H sync signal or equalization pulse.
And, H sync signal must not include V sync signal and equalization pulse.
V Sync Signal
No Good
(Equalization Pulse)
GoodNot Good
H Sync Signal
Note 3: When composite sync or sync-on-green signal is supplied, horizontal frequency must be 31kHz or
higher.
Note 4: Sync signal: Horizontal........................................................................... Positive or Negative
Minimum H. Sync width: 1Ms
Vertical.................................................. Positive or Negative
Minimum V. Sync width: 2H
Acceptable RGB Input Signal Timing
The following table lists acceptable RGB input signals. If you are using a signal similar
to one of the ones listed it may be accepted, however some projector settings may need
some adjustment.