Filter
Top Products
Section 4: Maintenance and Troubleshooting
RPMX/CX50/CX60/CX67 User’s Manual 4-5
STEP 1 – Power down the projector and unplug – Press
Power
to turn the
projector off. Allow the fans to stop before unplugging it from the AC outlet.
WARNINGS
It is recommended that you allow the lamp to cool
for approximately 5 minutes before removing it from
the lamp module.
STEP 2 – Access the lamp module
(a) Loosen the 2 screws securing the lamp door to the side of the PHM module.
(Figure 4.1.)
Figure 4.1.
(b) Swing the lamp door open. (Figure 4.2.) NOTE: The lamp door is hinged to
the base of the module.
Figure 4.2.
STEP 3 - Remove the lamp
WARNINGS
Do not touch the glass surface of the lamp when
removed from the lamp module. Set it aside for
proper disposal once it has cooled down.
Keep lamp level when removing from lamp module
to prevent damaging the terminal block.
Do not touch the surface of the optical integrator.
Fingerprints or scratches can damage this optical
component.
(a) Turn the lock ring to the OPEN position. (Figure 4.3.)