Filter
Top Products
Section 4: Maintenance and Troubleshooting
4-2 RPMX/CX50/CX60/CX67 User’s Manual
stops, excessive force, and uneven surfaces may cause the projector and cart
combination to overturn.
The projector is designed to operate with a 120W UHP lamp. A lamp that has
reached the end of its life or has failed should be replaced with a good lamp as
soon as possible.
WARNING
Turn off the projector before replacing a lamp. Wait
approximately 5 minutes to allow the lamp to cool
before removing.
The lamp is under great pressure when hot and may
explode, causing personal injury and/or property damage.
Always allow the lamp to cool before handling and/or
powering down and unplugging the projector.
Use only the lamp specified and supplied by
CHRISTIE in the Lamp Replacement Kit.
The lamp operates at a very high temperature and pressure.
Failure to allow the lamp to sufficiently cool prior to handling
could result in an explosion causing personal injury and/or
property damage. Wait at least 5 minutes before unplugging the
projector. This provides enough time for the internal lamp cooling
fans to cool the lamp and to automatically shut off. Allow the
lamp to cool completely before handling.
Only use attachments or accessories recommended by the manufacturer. Use of
others may result in the risk of fire, shock or personal injury.
WARNING
Use an appropriately rated AC power cord with the
projector. The power cord supplied is approved for North
American use only.
Do not attempt operation if the AC supply is not within the
specified voltage and power range.
Do not allow anything to rest on the power cord. Locate the projector where the
power cord cannot be abused by persons walking on it or objects rolling over it.
Operate the projector at the specified voltage. Do not overload power outlets and
extension cords as this can result in fire or shock hazards.
The projector is equipped with a three-wire plug having a third (grounding) pin.
This is a safety feature. If you are unable to insert the plug into the outlet, contact
an electrician to have the outlet replaced. Do not defeat the safety purpose of the
grounding-type plug.
NOTE: The power cord supplied with the projector is
approved for North American use only. An appropriately rated power cord with
IEC320 type plug is required for European and other countries.
Lam
p
'
Power cord
'
and Attachments