Filter
Top Products
Contents
xii
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-02
CHAPTER
11 Configuring Interface Characteristics 11-1
Understanding Interface Types 11-1
Port-Based VLANs 11-2
Switch Ports 11-2
Access Ports 11-3
Trunk Ports 11-3
Tunnel Ports 11-4
Routed Ports 11-4
Switch Virtual Interfaces 11-5
EtherChannel Port Groups 11-5
10-Gigabit Ethernet Interfaces 11-6
Power over Ethernet Ports 11-6
Supported Protocols and Standards 11-6
Powered-Device Detection and Initial Power Allocation 11-7
Power Management Modes 11-8
Power Monitoring and Power Policing 11-9
Connecting Interfaces 11-11
Ethernet Management Port 11-12
Using Interface Configuration Mode 11-15
Procedures for Configuring Interfaces 11-16
Configuring a Range of Interfaces 11-17
Configuring and Using Interface Range Macros 11-19
Configuring Ethernet Interfaces 11-20
Default Ethernet Interface Configuration 11-21
Configuring Interface Speed and Duplex Mode 11-22
Speed and Duplex Configuration Guidelines 11-22
Setting the Interface Speed and Duplex Parameters 11-23
Configuring IEEE 802.3x Flow Control 11-24
Configuring Auto-MDIX on an Interface 11-25
Configuring a Power Management Mode on a PoE Port 11-26
Budgeting Power for Devices Connected to a PoE Port 11-27
Configuring Power Policing 11-29
Adding a Description for an Interface 11-30
Configuring Ethernet Management Ports 11-31
Configuring Layer 3 Interfaces 11-31
Configuring the System MTU 11-33
Configuring the Cisco Redundant Power System 2300 11-35