Filter
Top Products
Contents
xxxvii
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-02
Controlling Source Information that Your Switch Originates 43-9
Redistributing Sources 43-9
Filtering Source-Active Request Messages 43-11
Controlling Source Information that Your Switch Forwards 43-12
Using a Filter 43-12
Using TTL to Limit the Multicast Data Sent in SA Messages 43-14
Controlling Source Information that Your Switch Receives 43-14
Configuring an MSDP Mesh Group 43-16
Shutting Down an MSDP Peer 43-16
Including a Bordering PIM Dense-Mode Region in MSDP 43-17
Configuring an Originating Address other than the RP Address 43-18
Monitoring and Maintaining MSDP 43-19
CHAPTER
44 Configuring Fallback Bridging 44-1
Understanding Fallback Bridging 44-1
Fallback Bridging Overview 44-1
Fallback Bridging and Switch Stacks 44-3
Configuring Fallback Bridging 44-3
Default Fallback Bridging Configuration 44-4
Fallback Bridging Configuration Guidelines 44-4
Creating a Bridge Group 44-4
Adjusting Spanning-Tree Parameters 44-6
Changing the VLAN-Bridge Spanning-Tree Priority 44-7
Changing the Interface Priority 44-7
Assigning a Path Cost 44-8
Adjusting BPDU Intervals 44-9
Disabling the Spanning Tree on an Interface 44-11
Monitoring and Maintaining Fallback Bridging 44-11
CHAPTER
45 Troubleshooting 45-1
Recovering from a Software Failure 45-2
Recovering from a Lost or Forgotten Password 45-3
Procedure with Password Recovery Enabled 45-5
Procedure with Password Recovery Disabled 45-7
Preventing Switch Stack Problems 45-8
Recovering from a Command Switch Failure 45-9
Replacing a Failed Command Switch with a Cluster Member 45-10
Replacing a Failed Command Switch with Another Switch 45-11