Filter
Top Products
11-37
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-02
Chapter 11 Configuring Interface Characteristics
Configuring the Power Supplies
To return to the RPS 2300 default settings, use these commands:
• To return to the default name setting (no name is configured), use the power rps switch-number
port rps-port-id name ““ user EXEC command with no space between the quotation marks.
• To return to the default port mode, use the power rps switch-number port rps-port-id active
command.
• To return to the default port priority, use the power rps switch-number port rps-port-id priority
command.
For more information about using the power rps user EXEC command, see the command reference for
this release.
Configuring the Power Supplies
You can enter the power supply user EXEC command to configure and manage the internal power
supply on the switch.
Note The Catalyst 3750 and 3560 switches do not support the power supply command.
Beginning in user EXEC mode, follow these steps to configure and manage the power supply:
The switch does not support the no power supply user EXEC command. To return to the default setting,
use the power supply switch-number on command.
Step 3
power rps switch-number priority priority Set the priority of the RPS 2300 port. The range is
from 1 to 6, where 1 is the highest priority and 6 is
the lowest priority.
The default port priority is 6.
Step 4
show env rps Verify your settings.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration
file.
Command Purpose
Command Purpose
Step 1
power supply switch-number {off | on} Set the switch power supply to off or on by using
one of these keywords:
• off—Set the power supply off.
• on—Set the power supply on.
The switch-number is supported only on
Catalyst 3750-E switches.
By default, the switch power supply is on.
Step 2
show env power Verify your settings.
Step 3
copy running-config startup-config (Optional) Save your entries in the configuration
file.