Filter
Top Products
User Guide NetXtreme II
January 2010
Broadcom Corporation
Document ENGSRVT52-CDUM100-R Viewing or Modifying Adapter Properties Page 143
TxPacketsPer=
Enables allowing an interrupt to occur after a specific amount of packets is transmitted.
Min = 0 (Disabled)
Max = 100
The default value is 20.
RxPacketsPer=
Enables allowing an interrupt to occur after a specific amount of packets is received.
Min = 0 (Disabled)
Max = 100
The default value is 75.
CheckSum=
Enables or disables the transmit and receive checksum offload feature. Checksum offload support is only for TCP/IP
packets; therefore, the default setting for checksum offload is OFF.
OFF
ON
TX
RX
FlowCtrl=
This keyword allows enabling/disabling of transmit and receive flow control.
BOTH
RX
TX
OFF
The default setting is OFF.
PDriver=
Enables the driver to operate in persistent driver mode. Use only if the adapter is placed in a hot-plug slot and only if you
must swap with an adapter that is exactly the same.
OFF
ON
The default setting is OFF.