Filter
Top Products
NetXtreme II User Guide
January 2010
Broadcom Corporation
Page 228 Performing Diagnostics Document ENGSRVT52-CDUM100-R
PERFORMING DIAGNOSTICS
At the MS-DOS prompt, type uxdiag (for BCM5706/BCM5708/BCM5709 network adapters) or uediag (for BCM57710
network adapters) followed by the command options. The uxdiag command options are shown in Table 1 and the uediag
command options are shown in Table 2. For example, to run all diagnostic tests on adapter #1 except Group B tests:
C:\>uxdiag -c 1 -t b
NOTE: You must include uxdiag or uediag at the beginning of the command string each time you type a command.
Table 1: uxdiag Command Options
Command Options Description
uxdiag Performs all tests on all Broadcom NetXtreme II adapters in your system.
uxdiag -c <devnum> Specifies the adapter (devnum) to test. Use all in place of a specific device number to test
all adapters.
uxdiag -cof Allows tests to continue after detecting a failure.
uxdiag -F Forces an upgrade of the image without checking the version.
uxdiag -fbc <bc_image> Specifies the bin file to update the bootcode.
uxdiag -fib <ib_image> Specifies the bin file for iSCSI boot.
uxdiag -fibc Programs the iSCSI configuration block. Used only with -fib <ib_image>.
uxdiag -fibp Programs the iSCSI configuration software. Used only with -fib <ib_image>.
uxdiag -fipmi <ipmi_image> Specifies the bin file to update IPMI firmware.
uxdiag -fmba <mba_image> Specifies the bin file to update the MBA.
uxdiag -fncsi <ncsi_image> Specifies the bin file to update the NCSI firmware.
uxdiag -fnvm <raw_image> Programs the raw image into NVM.
uxdiag -fump <ump_image> Specifies the bin file to update UMP firmware.
uxdiag -help Displays the Broadcom NetXtreme II User Diagnostics (uxdiag) command options.
uxdiag -I <iteration num> Specifies the number of iterations to run on the selected tests.
uxdiag -idmatch Enables matching of VID, DID, SVID, and SSID from the image file with device IDs. Used
only with -fnvm <raw_image>.
uxdiag -log <file> Logs the test results to a specified log file.
uxdiag -mba <1/0> Enables/disables Multiple Boot Agent (MBA) protocol.
1 = Enable
0 = Disable
uxdiag -mbap <n> Sets the MBA boot protocol.
0 = PXE
1 = RPL
2 = BOOTP
3 = iSCSI_Boot