Filter
Top Products
NetXtreme II User Guide
January 2010
Broadcom Corporation
Page 70 Safety Precautions Document ENGSRVT52-CDUM100-R
Novell NetWare
Novell NetWare 6.5 with the latest support pack.
Linux
Although the adapter driver should work with many Linux kernel versions and distributions, it has only been tested on 2.4x
kernels (starting from 2.4.24) and 2.6.x kernels. The driver may not compile on kernels older than 2.4.24. Testing is
concentrated on i386 and x86_64 architectures. Only limited testing has been done on other architectures. Minor changes
to some source files and Makefile may be needed on some kernels.
NOTE: Support for the 2.4.21 kernels is provided in Red Hat Enterprise Linux 3.
VMware ESX
VMware ESX 3.5
SAFETY PRECAUTIONS
CAUTION! The adapter is being installed in a system that operates with voltages that can be lethal. Before you open
the case of your system, observe the following precautions to protect yourself and to prevent damage to the system
components.
• Remove any metallic objects or jewelry from your hands and wrists.
• Make sure to use only insulated or nonconducting tools.
• Verify that the system is powered OFF and is unplugged before you touch internal components.
• Install or remove adapters in a static-free environment. The use of a properly grounded wrist strap or other
personal antistatic devices and an antistatic mat is strongly recommended.
PREINSTALLATION CHECKLIST
1. Verify that your system meets the hardware and software requirements listed under System Requirements.
2. Verify that your system is using the latest BIOS.
NOTE: If you acquired the adapter software on a disk, verify the path to the adapter driver files.
1. If your system is active, shut it down.
2. When system shutdown is complete, turn off the power and unplug the power cord.
3. Remove the adapter from its shipping package and place it on an antistatic surface.
4. Check the adapter for visible signs of damage, particularly on the edge connector. Never attempt to install a damaged
adapter.