Filter
Top Products
NetXtreme II User Guide
January 2010
Broadcom Corporation
Page 230 Performing Diagnostics Document ENGSRVT52-CDUM100-R
Table 2: uediag Command Options
Command Options Description
uediag Performs all tests on all Broadcom NetXtreme II adapters in your system.
uediag -c <device#> Specifies the adapter (device#) to test. Similar to -dev (for backward compatibility).
uediag -cof Allows tests to continue after detecting a failure.
uediag -dev <device#> Specifies the adapter (device#) to test.
uediag -F Forces an upgrade of the image without checking the version.
uediag -fbc <bc_image> Specifies the bin file to update the bootcode.
uediag -fbc1 <bc1_image> Specifies the bin file to update bootcode 1.
uediag -fbc2 <bc2_image> Specifies the bin file to update bootcode 2.
uediag -fl2b <l2b_image> Specifies the bin file for L2B firmware.
uediag -fib <ib_image> Specifies the bin file for iSCSI boot.
uediag -fibc Programs iSCSI configuration block 0. Used only with -fib <ib_image>.
uediag -fibc2 Programs iSCSI configuration block 1. Used only with -fib <ib_image>.
uediag -fibp Programs iSCSI configuration software. Used only with -fib <ib_image>.
uediag -fipmi <ipmi_image> Specifies the bin file to update IPMI firmware.
uediag -fmba <mba_image> Specifies the bin file to update the MBA.
uediag -fnvm <raw_image> Programs the raw image into NVM.
uediag -fump <ump_image> Specifies the bin file to update UMP firmware.
uediag -help Displays the Broadcom NetXtreme II User Diagnostics (uediag) command options.
uediag -I <iteration#> Specifies the number of iterations to run on the selected tests.
uediag -idmatch Enables matching of VID, DID, SVID, and SSID from the image file with device IDs: Used
only with -fnvm <raw_image>.
uediag -log <logfile> Logs the tests results to a specified log file.
uediag -mba <1/0> Enables/disables Multiple Boot Agent (MBA) protocol.
1 = Enable
0 = Disable
uediag -mbap <n> Sets the MBA boot protocol.
0 = PXE
1 = RPL
2 = BOOTP
3 = iSCSI_Boot
uediag -mbav <1/0> Enables/disables MBA VLAN.
1 = Enable
0 = Disable
uediag -mbavval <n> Sets MBA VLAN (<65536).
uediag -mfw <1/0> Enables/disables management firmware.
1 = Enable
0 = Disable
uediag -t <groups/tests> Disables certain groups/tests.
uediag -T <groups/tests> Enables certain groups/tests.
uediag -ver Displays the version of Broadcom NetXtreme II User Diagnostics (uediag) and all installed
adapters.