Filter
Top Products
User Guide NetXtreme II
January 2010
Broadcom Corporation
Document ENGSRVT52-CDUM100-R Appendix A: Event Log Messages Page 61
INTERMEDIATE DRIVER (VIRTUAL ADAPTER/TEAM)
The intermediate driver is identified by source BLFM, regardless of the base driver revision. Table 9 lists the event log
messages supported by the intermediate driver, explains the cause for the message, and provides the recommended action.
Table 9: Intermediate Driver Event Log Messages
System
Event
Message
Number
Severity Message Cause Corrective Action
1 Informational Event logging enabled for
Broadcom Advanced Server
Program driver.
– No action is required.
2 Error Unable to register with
NDIS.
The driver cannot register
with the NDIS interface.
Unload other NDIS drivers.
3 Error Unable to instantiate the
management interface.
The driver cannot create a
device instance.
Reboot the operating
system.
4 Error Unable to create symbolic
link for the management
interface.
Another driver has created a
conflicting device name.
Unload the conflicting device
driver that uses the name
Blf
.
5 Informational Broadcom Advanced Server
Program Driver has started.
The driver has started. No action is required.
6 Informational Broadcom Advanced Server
Program Driver has
stopped.
The driver has stopped. No action is required.
7 Error Could not allocate memory
for internal data structures.
The driver cannot allocate
memory from the operating
system.
Close running applications
to free memory.
8 Warning Could not bind to adapter. The driver could not open
one of the team physical
adapters.
Unload and reload the
physical adapter driver,
install an updated physical
adapter driver, or replace
the physical adapter.
9 Informational Successfully bind to
adapter.
The driver successfully
opened the physical
adapter.
No action is required.
10 Warning Network adapter is
disconnected.
The physical adapter is not
connected to the network (it
has not established link).
Check that the network
cable is connected, verify
that the network cable is the
right type, and verify that the
link partner (switch or hub) is
working correctly.
11 Informational Network adapter is
connected.
The physical adapter is
connected to the network (it
has established link).
No action is required.
12 Error Broadcom Advanced
Program Features Driver is
not designed to run on this
version of Operating
System.
The driver does not support
the operating system on
which it is installed.
Consult the driver release
notes and install the driver
on a supported operating
system or update the driver.
13 Informational Hot-standby adapter is
selected as the primary
adapter for a team without a
load balancing adapter.
A standby adapter has been
activated.
Replace the failed physical
adapter.