Filter
Top Products
25-9
Cisco ASA Series Firewall ASDM Configuration Guide
Chapter 25 Configuring the ASA for Cisco Cloud Web Security
Configuring Cisco Cloud Web Security
Detailed Steps
Step 1 Choose Configuration > Device Management > Cloud Web Security.
Step 2 In the Primary Server area, enter the following:
• IP Address/Domain Name—Enter the IPv4 address or FQDN of the primary server.
• HTTP Port—Enter the HTTP port of the primary server (port to which traffic must be redirected).
By default the port is 8080; do not change this value unless directed to do so.
Step 3 In the Backup Server area, enter the following:
• IP Address/Domain Name—Enter the IPv4 address or FQDN of the backup server.
• HTTP Port—Enter the HTTP port of the backup server (port to which traffic must be redirected).
By default the port is 8080. Valid values are from 1 to 65535.
Step 4 In the Other area, enter the following:
• Retry Counter—Enter the value for the number of consecutive polling failures to the Cloud Web
Security proxy server before determining the server is unreachable. Polls are performed every 30
seconds. Valid values are from 2 to 100, and the default is 5.
• License Key—Configure the authentication key that the ASA sends to the Cloud Web Security proxy
servers to indicate from which organization the request comes. The authentication key is a 16-byte
hexidecimal number. See the “Authentication Keys” section on page 25-3.
• Confirm License Key—Confirm the authentication key.
Step 5 Click Apply.