Filter
Top Products
27-9
Cisco ASA Series Firewall ASDM Configuration Guide
Chapter 27 Configuring Threat Detection
Configuring Scanning Threat Detection
• Feature History for Scanning Threat Detection, page 27-11
Information About Scanning Threat Detection
A typical scanning attack consists of a host that tests the accessibility of every IP address in a subnet (by
scanning through many hosts in the subnet or sweeping through many ports in a host or subnet). The
scanning threat detection feature determines when a host is performing a scan. Unlike IPS scan detection
that is based on traffic signatures, the ASA scanning threat detection feature maintains an extensive
database that contains host statistics that can be analyzed for scanning activity.
The host database tracks suspicious activity such as connections with no return activity, access of closed
service ports, vulnerable TCP behaviors such as non-random IPID, and many more behaviors.
If the scanning threat rate is exceeded, then the ASA sends a syslog message (733101), and optionally
shuns the attacker. The ASA tracks two types of rates: the average event rate over an interval, and the
burst event rate over a shorter burst interval. The burst event rate is 1/30th of the average rate interval or
10 seconds, whichever is higher. For each event detected that is considered to be part of a scanning
attack, the ASA checks the average and burst rate limits. If either rate is exceeded for traffic sent from
a host, then that host is considered to be an attacker. If either rate is exceeded for traffic received by a
host, then that host is considered to be a target.
Caution The scanning threat detection feature can affect the ASA performance and memory significantly while
it creates and gathers host- and subnet-based data structure and information.
Guidelines and Limitations
This section includes the guidelines and limitations for this feature:
Security Context Guidelines
Supported in single mode only. Multiple mode is not supported.
Firewall Mode Guidelines
Supported in routed and transparent firewall mode.
Types of Traffic Monitored
• Only through-the-box traffic is monitored; to-the-box traffic is not included in threat detection.
• Traffic that is denied by an ACL does not trigger scanning threat detection; only traffic that is
allowed through the ASA and that creates a flow is affected by scanning threat detection.