Filter
Top Products
41
Cisco TelePresence System Codec C90 and Prole 65” Dual using C90 Administrator guide
D14635.05 Prole C90 and Codec C90 Administrator Guide TC4.1, February 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Conference [1..1] MaxReceiveCallRate
Specify the maximum receive call rate to be used when placing or receiving calls.
Requires user role: ADMIN
Value space: <64..6000>
Range: Select a value from 64 to 6000 kbps.
Example: Conference 1 MaxReceiveCallRate: 6000
Conference [1..1] VideoBandwidth Mode
Set the conference video bandwidth mode.
Requires user role: ADMIN
Value space: <Dynamic/Static>
Dynamic: The available transmit bandwidth for the video channels are distributed among the
currently active channels. If there is no presentation, the main video channels will use the
bandwidth of the presentation channel.
Static: The available transmit bandwidth is assigned to each video channel, even if it is not active.
Example: Conference 1 VideoBandwidth Mode: Dynamic
Conference [1..1] VideoBandwidth MainChannel Weight
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel weight is
2 and the presentation channel weight is 1, then the main channel will use twice as much bandwidth
as the presentation channel.
Requires user role: ADMIN
Value space: <1..10>
Range: 1 to 10.
Example: Conference 1 VideoBandwidth MainChannel Weight: 5
Conference [1..1] VideoBandwidth PresentationChannel Weight
The available transmit video bandwidth is distributed on the main channel and presentation channel
according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel weight is
2 and the presentation channel weight is 1, then the main channel will use twice as much bandwidth
as the presentation channel.
Requires user role: ADMIN
Value space: <1..10>
Range: 1 to 10.
Example: Conference 1 VideoBandwidth PresentationChannel Weight: 5
Conference [1..1] PacketLossResilience Mode
Set the packetloss resilience mode. This conguration will only take eect for calls initiated after the
conguration is set.
Requires user role: ADMIN
Value space: <On/Off>
On: Enable the packetloss resilience.
O: Disable the packetloss resilience.
Example: Conference 1 PacketLossResilience Mode: On
Contents
Contact us
Introduction
Advanced conguration
Password protection
Web interface
Appendices
Advanced conguration