Filter
Top Products
72
Cisco TelePresence System Codec C90 and Prole 65” Dual using C90 Administrator guide
D14635.05 Prole C90 and Codec C90 Administrator Guide TC4.1, February 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Set a root password
If you log in to the command line interface as root, you can
access the codec’s le system.
The root user is disabled by default.
Perform the following steps to activate the root user and set a
password:
1. Connect to the codec through the network or the serial data
port, using a command line interface (SSH or Telnet).
2. Log in to the codec with the username (admin) and
password. You need ADMIN rights.
3. Run the following API command:
systemtools rootsettings on <password>
NOTE: The root password is not the same as the administrator
password.
Change the user passwords
All users can change their own codec password as described
on the previous page.
If you have ADMIN rights, you can change all users’ passwords
by performing the following steps:
1. Log in to the web interface with username and password.
2. Go to the Users page.
3. Select the appropriate user from the list.
4. Enter a new password and PIN code.
5. Click Save.
Contents
Contact us
Introduction
Advanced conguration
Password protection
Web interface
Appendices
Password protection