Filter
Top Products
66
Cisco TelePresence System Codec C90 and Prole 65” Dual using C90 Administrator guide
D14635.05 Prole C90 and Codec C90 Administrator Guide TC4.1, February 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Video WallPaper
Determine if a background picture should be displayed on screen when idle.
Requires user role: USER
Value space: <None/Growing/Summersky/Custom>
None: No wallpaper will be displayed on screen.
Summersky, Growing: Select one of the predened wallpapers to be displayed on screen.
Custom: Custom: The custom wallpaper must be uploaded to the codec from the web interface.
1) On the video system: Find the IP address of the codec. Open the menu on screen and go to
Home > Settings > System information to nd the IP Address.
2) On your computer: Open a web browser and enter the IP address of the codec. Select
"Wallpaper" from the menu, browse for the le, and press the "Upload" button.
3) On the video system: Open the menu on screen and go to Home > Settings > Wallpaper >
Custom. Give it a few seconds to display the new picture. If the picture does not show, toggle
once between "None" and "Custom" wallpaper to make the change take eect.
Example: Video Wallpaper: Summersky
The Experimental settings
The Experimental settings are beta preview features and can be used 'as is'. They are not fully
documented.
NOTE: The Experimental settings are likely to change without further notice.
Experimental AudioTracking Camera [1..7] Mode
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requires user role: ADMIN
Value space: <On/Off>
Example: Experimental AudioTracking Camera 1 Mode: Off
Experimental BrightnessGradient Camera [1..7] Mode
NOTE: Applies to Cisco TelePresence T1/T3. The Experimental settings can be used 'as is' and will
not be further documented. NOTE: The Experimental settings WILL change.
This settings can be congured from the command line interface, and not from the menu.
Requires user role: ADMIN
Value space: <On/Off>
On: Enable row dependent digital gain.
O: Disable row dependent digital gain.
Example: Experimental BrightnessGradient Camera 1 Mode: Off
Experimental BrightnessGradient Camera [1..7] Level
The Experimental settings can be used 'as is' and will not be further documented. NOTE: The
Experimental settings WILL change.
NOTE: Applies to Cisco TelePresence T1/T3. This settings can be congured from the command
line interface, and not from the menu. Set the camera brightness gradient level to control the row
dependent digital gain for the top row of the image. The gain gradient is applied so that intermediate
rows have gains that are determined by linear interpolation of the top row gain and the gain for the
bottom row. A gain of 1.0x is always applied to the bottom row of the image.
Requires user role: ADMIN
Value space: <10..39>
Range: The range 10 to 39 corresponds to gains in the range 1.0x to 3.9x.
Example: Experimental BrightnessGradient Camera 1 Level: 10
Contents
Contact us
Introduction
Advanced conguration
Password protection
Web interface
Appendices
Advanced conguration