68
Cisco TelePresence System Codec C90 and Prole 65” Dual using C90 Administrator guide
D14635.05 Prole C90 and Codec C90 Administrator Guide TC4.1, February 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
Experimental NetworkServices UPnP Mode
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requires user role: ADMIN
Value space: <On/Off>
Example: Experimental NetworkServices UPnP Mode: Off
Experimental NetworkServices UPnP Timeout
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requires user role: ADMIN
Value space: <0..3600>
Example: Experimental NetworkServices UPnP Timeout: 0
Experimental Audio Input Microphone [1..8] EchoControl HighPassFilter
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requires user role: ADMIN
Value space: <On/Off>
Example: Experimental Audio Input Microphone 1 EchoControl HighPassFilter:
Off
Experimental Audio Input Microphone [1..8] Channel
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Dene whether the microphone connector is a mono signal or part of a multichannel signal.
Requires user role: ADMIN
Value space: <Left/Right/Mono>
Left: The microphone signal is the left channel of a stereo signal.
Right: The microphone signal is the right channel of a stereo signal.
Mono: The microphone signal is a mono signal.
Example: Experimental Audio Input Microphone 1 Channel: Mono
Experimental Audio MicrophoneReinforcement Gain
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Microphone reinforcement is local amplication of one or several input connectors, directly to one or
several output connectors, with minimum delay.
For software version TC4.0: Microphone reinforcement should not be enabled on a codec that is also
congured using the Audio Console application.
This setting congures the gain of this path, from -53 dB to +15 dB. The value -54 corresponds to
mute.
Requires user role: ADMIN
Value space: <-54..15>
Example: Experimental Audio MicrophoneReinforcement Gain: -19
Experimental Audio MicrophoneReinforcement AGC
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Microphone reinforcement is local amplication of one or several input connectors, directly to one or
several output connectors, with minimum delay.
For software version TC4.0: Microphone reinforcement should not be enabled on a codec that is also
congured using the Audio Console application.
This setting controls an AGC on the mix of all input connectors attached to the Microphone
reinforcement.
Requires user role: ADMIN
Value space: <On/Off>
Example: Experimental Audio MicrophoneReinforcement AGC: Off
Experimental Audio MicrophoneReinforcement Input Microphone [1..8] Mode
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Microphone reinforcement is local amplication of one or several input connectors, directly to one or
several output connectors, with minimum delay.
For software version TC4.0: Microphone reinforcement should not be enabled on a codec that is also
congured using the Audio Console application.
Conguring this setting to On for a microphone, means to attach it to the microphone reinforcement
for local amplication. This is done in parallel to the microphone's existing connections, and will not
aect any of these.
Requires user role: ADMIN
Value space: <On/Off>
Example: Experimental Audio MicrophoneReinforcement Input Microphone 1 Mode:
On
Contents
Contact us
Introduction
Advanced conguration
Password protection
Web interface
Appendices
Advanced conguration