Filter
Top Products
1-82
Cisco Media Gateway Controller Software Release 9 Billing Interface Guide
OL-1089-11
Chapter 1 Billing Interfaces
CDE Detail Description
010/1000/40 Permanent frame mode connection
operational—included in a STATUS message
to indicate that a permanently established
frame mode connection is operational and
capable of carrying user information (see
Annex A/Q.933).
DSS 1 Q.933
010/1001/41 Temporary failure—indicates that the
network is not functioning correctly and that
the condition is not likely to last a long period
of time (for example, the user may wish to try
another call attempt almost immediately).
DSS 1, ISUP Q.931 U, RPN,
RLN, LN
010/1010/42 Switching equipment congestion—indicates
that the switching equipment generating this
cause is experiencing a period of high traffic.
DSS 1, ISUP TN, RLN,
INTL
2.9.9.1/
Q.764
TN, RLN Temporary
trunk block
(national use)
010/1011/43 Access information discarded—indicates that
the network could not deliver access
information to the remote user as requested,
that is, user-to-user information, low layer
compatibility, high layer compatibility, or
sub-address, as indicated in the diagnostic. It
is noted that the particular type of access
information discarded is optionally included
in the diagnostic.
DSS 1, ISUP Q.931 U, RPN,
LN
010/1100/44 Requested circuit/channel not
available—returned when the circuit or
channel indicated by the requesting entity
cannot be provided by the other side of the
interface.
DSS 1, ISUP Q.931 U, RPN,
LN
010/1110/46 Precedence call blocked—indicates that there
are no preemptable circuits or that the called
user is busy with a call of equal or higher
preemptable level.
DSS 1, ISUP Q.735.3,
Q.955.3
MLPP
010/1111/47 Resource unavailable, unspecified—used to
report a resource unavailable event only when
no other cause in the resource unavailable
class applies.
DSS 1, ISUP Q.931 U, RPN
Annex A/
Q.763
011/0001/49 Quality of Service not available—used to
report that the requested Quality of Service, as
defined in Recommendation X.213, cannot be
provided (for example, throughput or transit
delay cannot be supported).
DSS 1 Q.931
Table 1-53 Cause Information Element/Parameter Definitions (continued)
Cause
Class/Value/No. Definition
Application
(Note 1)
Reference
(Note 2)
Location
(Note 3) Remarks