Cisco Systems OL-1089-11 Network Hardware User Manual


 
1-77
Cisco Media Gateway Controller Software Release 9 Billing Interface Guide
OL-1089-11
Chapter 1 Billing Interfaces
CDE Detail Description
000/0010/2 No route to specified transit network (national
use)—indicates that the equipment sending
this cause has received a request to route the
call through a particular transit network which
it does not recognize. The equipment sending
this cause does not recognize the transit
network either because the transit network
does not exist or because that particular transit
network, while it does exist, does not serve the
equipment which is sending this cause.
This cause is supported on a
network-dependent basis.
DSS 1,
ISUP(NU)
Q.931 LN, TN
000/0010/3 No route to destination—indicates that the
called party cannot be reached because the
network through which the call has been
routed does not serve the destination desired.
This cause is supported on a network-
dependent basis.
DSS 1, ISUP Q.931 U, RPN,
LN
000/0100/4 Send special information tone— indicates that
the called party cannot be reached for reasons
that are of a long term nature and that the
special information tone should be returned to
the calling party.
ISUP Clause 7/Q.35
000/0101/5 Misdialled trunk prefix (national
use)—indicates the erroneous inclusion of a
trunk prefix in the called party number.
ISUP(NU)
000/0110/6 Channel unacceptable—indicates that the
channel most recently identified is not
acceptable to the sending entity for use in this
call.
DSS 1 Q.931 LN
000/0111/7 Call awarded and being delivered in an
established channelindicates that the user
has been awarded the incoming call, and that
the incoming call is being connected to a
channel already established to that user for
similar calls (for example, packet-mode X.25
virtual calls).
DSS 1 Q.931 LN
000/1000/8 Preemption—indicates that the call is being
pre-empted.
DSS 1, ISUP Q.735.3
Q.955.3
MLPP
000/1001/9 Preemption – circuit reserved for
reuse—indicates that the call is being
pre-empted and the circuit is reserved for
reuse by the pre-empting exchange.
ISUP Q.735.3 MLPP
Table 1-53 Cause Information Element/Parameter Definitions (continued)
Cause
Class/Value/No. Definition
Application
(Note 1)
Reference
(Note 2)
Location
(Note 3) Remarks