Filter
Top Products
1-137
Cisco Media Gateway Controller Software Release 9 Billing Interface Guide
OL-1089-11
Chapter 1 Billing Interfaces
CDE Detail Description
Source IP Address (Tag: 4204)
Ingress Media Device Address (Tag: 4205)
Table 1-148 Source IP Address Description Form
Name: Source IP Address Tag: 4204 Source: MDL
Description/Purpose: Identifies the source that sends the call setup message in incoming SIP and H.323 calls.
Format: IA5 (string) Length in Octets: 1 to 23
Data Value: IPV4 format. Example: 10.1.22.115.
Extended Data Value: No extended value.
General Information: The source IP address is used to look up a dial plan in the IP Address Table if the trunk group property,
EnableIPScreening, is set to 1.
MGC Release: Release 9.4(1) and later.
Table 1-149 Ingress Media Device Address Description Form
Name: Ingress Media Device Address Tag: 4205 Source: MDL
Description/Purpose: Identifies the IP address of the originating RTP end point. This is parsed from the SDP from SIP,
MGCP, or EISUP (HSI).
Format: IA5 (string) Length in Octets: 1 to 256
Data Value: IPV4 format or FQDN. Examples: 10.1.22.115, sp-46-39-gateway.customer.com.
Extended Data Value: No extended value.
General Information: If the ingress media device address is an IP address, it is used to look up a dial plan in the IP Address
Table if the trunk group properties, EnableIPScreening and SipIPSource, are set to 1. If the call is originated in the H.323
domain as a Slow Start call, this information is not present in the 1010 CDB. If the call is originated in the H.323 domain
as a Slow Start call and a switchover operation is performed on the Cisco PGW 2200, this information is not captured in
any CDB.
MGC Release: Release 9.4(1) and later.