Filter
Top Products
1-87
Cisco Media Gateway Controller Software Release 9 Billing Interface Guide
OL-1089-11
Chapter 1 Billing Interfaces
CDE Detail Description
110/0110/102 Recovery on timer expiry—indicates that a
procedure has been initiated by the expiry of a
timer in association with error handling
procedures.
DSS 1, ISUP Q.931
Q.733.4 RLN Terminal
portability:
expiry of
waiting RES
(user) timer
2.4.3/Q.764 INTL Expiry of
waiting RES
(network)
timer
(incoming
international
exchange)
110/0111/103 Parameter non-existent or not implemented –
passed on (national use)—indicates that the
equipment sending this cause has received a
message which includes parameters not
recognized because the parameters are not
defined or are defined but not implemented by
the equipment sending the cause. The cause
indicates that the parameter(s) were ignored.
In addition, if the equipment sending this
cause is an intermediate point, then this cause
indicates that the parameter(s) were passed on
unchanged.
ISUP(NU)
110/1110/110 Message with unrecognized parameter
discarded—indicates that the equipment
sending this cause has discarded a received
message which includes a parameter that is
not recognized.
ISUP 2.9.5.2/
Q.764,
2.9.5.3/
Q.764
110/1111/111 Protocol error, unspecified—used to report a
protocol error event only when no other cause
in the protocol error class applies.
DSS 1, ISUP Q.931 RLN
Annex A/
Q.763
RLN, TN,
INTL
Q.735.1 RLN CUG
111/1111/127 Interworking, unspecified—indicates that
there has been interworking with a network
which does not provide causes for actions it
takes. Thus, the precise cause for a message
which is being sent cannot be ascertained.
DSS 1, ISUP Q.931
Annex A/
Q.763
Note 1: Application indicates that the cause value may be carried in DSS 1 and/or ISUP. Causes carried in ISUP which are
not marked for national use (NU) are the minimum set of cause values that shall be supported over the international interface.
Note 2: The references included are not exhaustive.
Note 3: These are typical locations generated within the scope of the associated Recommendations. Other locations may be
used depending upon the network configuration.
Table 1-53 Cause Information Element/Parameter Definitions (continued)
Cause
Class/Value/No. Definition
Application
(Note 1)
Reference
(Note 2)
Location
(Note 3) Remarks