Filter
Top Products
5/26/05 Cisco 1030 Remote Edge Lightweight Access Points
OL-7426-03
The following figure shows a typical Cisco 1030 remote edge lightweight access point configuration:
Note that the Cisco 1030 remote edge lightweight access point must have a DHCP server available on
its local subnet, so it can obtain an IP address upon reboot. Also note that the Cisco 1030 remote edge
lightweight access points at each remote location must be on the same subnet to allow client roaming.
Refer to the following for more information on Cisco 1000 Series lightweight access points:
• Cisco 1000 Series Lightweight Access Points
• Cisco 1000 Series Lightweight Access Point Part Numbers
• Cisco 1000 Series Lightweight Access Point External and Internal Antennas
• Cisco 1000 Series Lightweight Access Point LEDs
• Cisco 1000 Series Lightweight Access Point Connectors
• Cisco 1000 Series Lightweight Access Point Power Requirements
• Cisco 1000 Series Lightweight Access Point External Power Supply
• Cisco 1000 Series Lightweight Access Point Mounting Options
• Cisco 1000 Series Lightweight Access Point Physical Security
• Cisco 1000 Series Lightweight Access Point Monitor Mode
• Cisco 1000 Series IEEE 802.11a/b/g Lightweight Access Point Deployment Guide
• Internal-Antenna AP1010 Cisco 1000 Series IEEE 802.11a/b/g Lightweight Access Point
Quick Start Guide
• External-Antenna AP1020 and AP1030 Cisco 1000 Series IEEE 802.11a/b/g Lightweight Access
Point Quick Start Guide