Filter
Top Products
B-13
Cisco uBR924 Software Configuration Guide
OL-0337-05 (8/2002)
Appendix B Using the Cable Monitor Tool
Sample Pages
Voice Ports Information
The Voice Ports Information page summarizes the current status of the two voice ports on the
Cisco uBR924 router. Figure B-3 shows a typical Voice Ports Information page.
Figure B-3 Voice Ports Page
Note The Voice Ports Information page has valid information only when the Cisco uBR924 router is running
a software image with voice support.
The Voice Ports Information page displays the same information that is shown using the show voice port
command:
• Transport Used—The type of network being used to make calls on each voice port:
–
VoIP—The voice call is using Voice over IP transmitted over the cable interface (default).
–
Analog—The voice call is using the PTSN cutover port, indicating that the cable interface is
down or that power was temporarily interrupted to the router.
• Type—The type of voice port (always “FXS” for the Cisco uBR924 router).
• Operation State—The current functional status of the voice port: