Filter
Top Products
2-8
Cisco uBR924 Software Configuration Guide
OL-0337-05 (8/2002)
Chapter 2 DOCSIS-Bridging Configuration
Cisco IOS Configuration File
Sample Configuration for DOCSIS-Compliant Bridging
The following shows a typical Cisco IOS configuration for a Cisco uBR924 router that is operating in
“plug and play” DOCSIS-compliant bridging mode.
version 12.1
service config
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname ubr924
!
clock timezone - 4
ip subnet-zero
no ip routing
!
voice-port 0
!
voice-port 1
!
interface Ethernet0
no ip directed-broadcast
no ip route-cache
bridge-group 59
bridge-group 59 spanning-disabled
!
interface cable-modem0
ip address dhcp
no ip directed-broadcast
no ip route-cache
bridge-group 59
bridge-group 59 spanning-disabled
!
ip classless
no ip http server
no service finger
!
!
line con 0
transport input none
line vty 0 4
!
end
This configuration shows the following requirements for DOCSIS-compliant bridging:
• IP routing is disabled.
• No IP address is assigned to the cable interface; instead, the ip address dhcp command indicates
that a DHCP server assigns an IP address to the cable interface. The Ethernet interface uses the same
IP address because the router is acting as a bridge between the two interfaces, making them part of
the same IP network—when the router is in DOCSIS-bridging mode, the IP addresses are
automatically assigned during the provisioning process.