Filter
Top Products
G-2 Upgrading from the SMART-2 and SMART SCSI Array Controllers
Writer: Rickard Project: Compaq Smart Array 3200 Controller Reference Guide Comments: 340862-002
File Name: N-APPG.DOC Last Saved On: 12/8/98 11:15 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
3. Upgrade your System ROM to the most current version using the
Compaq System ROMPaq. The System ROM must be upgraded before
installing the Smart Array 3200 Controller. Your Smart Array 3200
Controller option kit may include a diskette containing Systems
ROMPaq. If so, use the diskette to upgrade the system ROM. Otherwise,
Systems ROMPaq is distributed on the Compaq SmartStart and Support
Software CD included in the Smart Array 3200 Controller option kit.
Review Chapter 3 in this guide for specific instructions on running
Systems ROMPaq.
4. Perform a normal shutdown and turn OFF the server.
5. It is important to understand the difference between SCSI cable
connector layouts for the SMART Controller, SMART-2 controllers, and
Smart Array 3200 Controllers. See Figures F-1 and F-2.
The SMART Controller has a 100-pin external connector on the
mounting bracket that connects to the Y cable that separates into two
50-pin Fast-SCSI-2 connectors, Port 1 and Port 2. These port numbers
should be labeled on the Y cable and can be connected to external drives
in Compaq ProLiant Storage Systems or other external storage units.
Port 1 is also available as an internal connector on the top edge of the
controller for internal drive connections. Port 1 can be used either
internally or externally, but not both at the same time. Note the existing
cable connections and port numbers for your system before
disconnecting any cables.
The SMART-2DH Controller has an external 68-pin Fast-Wide SCSI-2
connector on the mounting bracket for Port 2 only. There is an internal
68-pin Fast-Wide SCSI-2 connector at the top edge of the controller for
Port 1. This port can be used for internal drives through a standard
internal ribbon cable, or for external drives through a special
internal/external cable (included) and a connector panel or slot connector
bracket (included) at the back of the server. This enables Port 1
connections to external drives in Compaq ProLiant Storage Systems.
There is no Y cable used with the SMART-2DH Controller.