Filter
Top Products
6-1
Compaq Smart Array 3200 Controller Reference Guide
Writer: Rickard Project: Compaq Smart Array 3200 Controller Reference Guide Comments: 340862-002
File Name: G-CH06.DOC Last Saved On: 12/7/98 9:23 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Chapter 6
Installing the Operating System
Drivers
This chapter outlines driver installation steps to set up the Smart Array 3200
Controller in a server running any of the following operating systems:
■ Novell NetWare 3.2, 4.2, and 5.0
■ Microsoft Windows NT 3.51 and 4.0
■ SCO OpenServer 5
■ SCO UnixWare 2.x and 7.x
■ IBM OS/2 WARP Server family
■ Banyan VINES 6.x, 7.x, and 8.x
This chapter also contains related information for using the Smart Array 3200
Controller with these operating systems. If you are setting up a new system,
Compaq recommends using SmartStart to install both the operating system
software and the device drivers for the Smart Array 3200 Controller.
NOTE: If you install the operating system software from the SmartStart and
Support Software CD, all the software, including device drivers, will be installed
automatically and configured for the Smart Array 3200 Controller. The Smart
Array 3200 Controller is supported by SmartStart 4.22 or later. Refer to the
documentation that came with SmartStart for installation instructions.
Before installing operating system drivers, you should have:
■ Updated your system firmware by running Systems ROMPaq
■ Installed the Smart Array 3200 Controller option board
■ Configured the hardware by running the System Configuration Utility
■ Used the Array Configuration Utility to configure your drive array(s)