Filter
Top Products
4-29
Using Set-Up Mode
Adjusting Top-of-Form Origin
Print positions often change gradually when you use the printer over long periods of time.
The ADJUST function allows you to adjust these positions by fine-tuning the Top-of-Form
origin.
The following table describes the ADJUST options and values. Options are listed in the
order they are printed.
ADJUST Options and Values
Overprinted values are the factory settings.
ADJUST
Options Values Description
<FNFOLD ADJ> Adjust the Top-of-Form origin for
continuous forms in increments of 1/60
inch (0.42mm) from the physical top of
the page.
###/60 IN -10 to 10 (0)
Number of 1/60 inches
<MNUAL ADJ> Adjust the Top-of-Form origin for
single sheets in increments of 1/60 inch
(0.42mm) from the physical top of the
page.
###/60 IN -10 to 10 (0)
Number of 1/60 inches
<RESVD 1> Reserved
<RESVD 2> Reserved
(Manual
Adjustment)
(Fanfold
Adjustment)