Filter
Top Products
6-3
Trouble-Shooting
Problem Solution
The top margin is wrong. The top margin is the sum of the printers top-of-form
setting, the software-specified top margin, and the
printers TOP-MRGN setting. Proceed as follows:
Make sure that the top-of-form setting is correct.
The factory default is 0 mm (0 inch). See the
section Changing Top of Form Origin in
Chapter 4, page 4-29.
Check the software-specified top margin. Refer to
your software documentation.
Check the printers TOP-MRGN setting. See the
section Changing Macro1 and Macro2 Options
in Chapter 4, page 4-18.
Check the line spacing setting in your software.
Change the LINE MODE setting in the printer Set-Up
mode to LF=LFCR=CR. See the section Changing
Macro1 and Macro2 Options in Chapter 4,
pages 4-18 and 4-19.
Change the LINE MODE setting in the printer Set-Up
mode to CR=LF+CR. See the section Changing
Macro1 and Macro2 Options in Chapter 4,
pages 4-18 and 4-19.
Change the LINE MODE setting in the printer Set-Up
mode to LF=LF+CR. See the section Changing
Macro1 and Macro2 Options in Chapter 4,
pages 4-18 and 4-19.
Change the LINE MODE setting in the printer Set-Up
mode to LFCR=LF+CR. See the section Changing
Macro1 and Macro2 Options in Chapter 4,
pages 4-18 and 4-19.
Lines are double spaced instead of
single spaced.
The printer overprints on the same
line.
The next print line starts where the
previous line ended instead of at
the left margin.
The printer overprints on the same
line while the next print line starts
where the previous line ended
instead of at the left margin.