Filter
Top Products
CY7C63310, CY7C638xx
Document 38-08035 Rev. *K Page 50 of 83
17. Interrupt Controller
The interrupt controller and its associated registers allow the
user’s code to respond to an interrupt from almost every
functional block in the enCoRe II devices. The registers
associated with the interrupt controller allow disabling interrupts
globally or individually. The registers also provide a mechanism
by which a user may clear all pending and posted interrupts, or
clear individual posted or pending interrupts.
The following table lists all interrupts and the priorities that are
available in the enCoRe II devices.
17.1 Architectural Description
An interrupt is posted when its interrupt conditions occur. This
results in the flip-flop in Figure 17-1. on page 51 clocking in a ‘1’.
The interrupt remains posted until the interrupt is taken or until it
is cleared by writing to the appropriate INT_CLRx register.
A posted interrupt is not pending unless it is enabled by setting
its interrupt mask bit (in the appropriate INT_MSKx register). All
pending interrupts are processed by the Priority Encoder to
determine the highest priority interrupt which is taken by the M8C
if the Global Interrupt Enable bit is set in the CPU_F register.
Disabling an interrupt by clearing its interrupt mask bit (in the
INT_MSKx register) does not clear a posted interrupt, nor does
it prevent an interrupt from being posted. It prevents a posted
interrupt from becoming pending.
Nested interrupts are accomplished by re-enabling interrupts
inside an interrupt service routine. To do this, set the IE bit in the
Flag Register.
A block diagram of the enCoRe II Interrupt Controller is shown in
Figure 17-1. on page 51.
Table 17-1. Interrupt Numbers, Priorities, Vectors
Interrupt
Priority
Interrupt
Address
Name
0 0000h Reset
1 0004h POR/LVD
2 0008h INT0
3 000Ch SPI Transmitter Empty
4 0010h SPI Receiver Full
5 0014h GPIO Port 0
6 0018h GPIO Port 1
7001ChINT1
8 0020h EP0
9 0024h EP1
10 0028h EP2
11 002Ch USB Reset
12 0030h USB Active
13 0034h 1 mS Interval timer
14 0038h Programmable Interval Timer
15 003Ch Timer Capture 0
16 0040h Timer Capture 1
17 0044h 16-bit Free Running Timer Wrap
18 0048h INT2
19 004Ch PS2 Data Low
20 0050h GPIO Port 2
21 0054h GPIO Port 3
22 0058h Reserved
23 005Ch Reserved
24 0060h Reserved
25 0064h Sleep Timer
[+] Feedback [+] Feedback