Filter
Top Products
104 Dell PowerConnect 28xx Systems User Guide
LAGs can be configured according to the following load balancing types: Layer 2, Layer 2 and Layer 3 or
Layer 3.
The LAG Configuration page contains fields for configuring parameters for configured LAGs. The
device supports up to eight LAGs, and each LAG can have up to eight members.
For information about
To open the
LAG Configuration page, click SwitchPorts LAG Configuration in the tree view.
If port configuration is modified while the port is a LAG member, the configuration change is only
effective after the port is removed from the LAG.
Figure 7-9. LAG Configuration
The LAG Configuration page contains the following fields:
•
Load Balance —
Indicates the load balancing type enabled on the LAG. The possible field values are:
–
Layer 2
— Enables load balancing based on static and dynamic MAC addresses.
–
Layer 3
— Enables load balancing based on source and destination IP addresses.
–
Layer 2-3
— Enables load balancing based on static and dynamic MAC addresses, and source and
destination IP addresses.
•
LAG
— The LAG number.
•
LAG Mode
— Indicates that the LAG mode is static.