Filter
Top Products
Configuring Switch Information 271
GARP Leave Timer (10 - 2147483640
) (Msec)— Time lapse, in milliseconds, that the device waits
before leaving its GARP state. Leave time is activated by a Leave All Time message sent/received,
and cancelled by the Join message received. Leave time must be greater than or equal to three
times the join time. The default value is 600 msec.
GARP Leave All Timer (10 - 2147483640)
(Msec) — Time lapse, in milliseconds, that all devices
wait before leaving the GARP state. The leave all time must be greater than the leave time
.
The default value is 10000 msec.
Defining GARP Timers
1
Open the
GARP Timers
page.
2
Select an interface.
3
Complete the fields.
4
Click
Apply Changes
.
The GARP parameters are saved to the device.
Copying Parameters in the GARP Timers Table
1
Open the
GARP Timers
page.
2
Click
Show All
.
The
GARP Timers Table
opens.
3
Select the interface type in the
Copy Parameters from
field.
4
Select an interface in either the
Port
or
LAG
drop-down menu.
The definitions for this interface are copied to the selected interfaces. See step 6.
5
Select the
Copy to
check box to define the interfaces to which the GARP timer definitions
are copied, or click
Select All
to copy the definitions to all ports or LAGs.
6
Click
Apply Changes
.
The parameters are copied to the selected ports or LAGs in the
GARP Timers Table
, and the
device is updated.