Filter
Top Products
326 Configuring Switch Information
www.dell.com | support.dell.com
Enabling Bridge Multicast Filtering on the device
1
Open the
Global Parameters
page.
2
Select
Enable
in the
Bridge Multicast Filtering
field.
3
Click
Apply Changes
.
Bridge Multicast
Filtering is enabled on the device.
Enabling IGMP Snooping on the device
1
Open the
Global Parameters
page.
2
Select
Enable
in the
IGMP Snooping Status
field.
3
Click
Apply Changes
.
IGMP Snooping is enabled on the device.
Enabling Multicast Filtering and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling Multicast Filtering
and IGMP Snooping as displayed on the
Global Parameters
page.
The following is an example of the CLI commands:
Adding Bridge Multicast Address Members
The
Bridge Multicast Group
page
displays the ports and LAGs attached to the Multicast service
group in the
Ports
and
LAGs
tables. The Port and LAG tables also reflect the manner in which the
port or LAGs joined the Multicast group. Ports can be added either to existing groups or to new
Table 7-89. Multicast Filtering and Snooping CLI Commands
CLI Command Description
bridge multicast filtering
Enables filtering of Multicast addresses.
ip igmp snooping
Enables Internet Group Membership Protocol
(IGMP) snooping.
console(config)# bridge multicast filtering
console(config)# ip igmp snooping