Filter
Top Products
54 Installing the PowerConnect 3424/P and PowerConnect 3448/P
www.dell.com | support.dell.com
Connecting a Device to a Power Supply
Connect the supplied AC power cable to the AC power connector on the back panel.
NOTE: Do not connect the power cable to a grounded AC outlet at this time. Connect the device to a
power source in the steps detailed in "Starting and Configuring the Device".
Figure 3-4. Back-Panel Power Connector
After connecting the device to a power source, confirm that the device is connected and operating
correctly by examining the LEDs on the front panel.
Installing a Stack
Overview
Each device can operate as a stand-alone device or can be a member in a stack. Up to six devices or
up to 192 ports are supported per stack.
All stacks must have a Master unit, and may have a Master Backup unit, with any other devices
connected to the stack as Members.
Stacking PowerConnect 3400 Series Switches
Each PowerConnect 3400 series stack contains a single Master unit, and may have a Master Backup
unit, while the remaining units are considered stacking Members.
Console Port
RPS Connector
Console Port
PowerConnect 3424/3448 Rear View
EPS Connector
Power Connector
Power Connector
PowerConnect 3424P/3448P Rear View