Filter
Top Products
308 Configuring Switch Information
www.dell.com | support.dell.com
PVID (1-4093 , 4095)
— Assigns a VLAN ID to untagged packets. The possible field values are 1-4095.
VLAN 4095 is defined as per standard and industry practice, as the Discard VLAN. Packets
classified to this VLAN are dropped.
Frame Type
— Packet type accepted by the LAG. Possible values are:
Admit Tag Only
— Only tagged packets are accepted by the LAG.
Admit All
— Tagged and untagged packets are both accepted by the LAG.
Ingress Filtering
— Enables or disables Ingress filtering by the LAG. Ingress filtering discards
packets that are destined to VLANs of which the specific LAG is not a member.
Current Reserve VLAN
— The VLAN currently designated as the reserved VLAN.
Reserve VLAN for Internal Use
— The VLAN that is designated as the reserved VLAN after the
device is reset.
Assigning VLAN LAG Settings:
1
Open the
VLAN LAG Settings
page.
2
Select a LAG from the
LAG
drop-down menu and complete the fields on the page.
3
Click
Apply Changes
.
The VLAN LAG parameters are defined, and the device is updated.
Displaying the VLAN LAG Table
1
Open the
VLAN LAG Settings
page.
2
Click
Show All
.
The
VLAN LAG Table
opens.
Assigning LAGs to VLAN Groups Using CLI Commands
The following table summarizes the equivalent CLI commands for assigning LAGs to VLAN
groups as displayed in the
VLAN LAG Settings
page.
Table 7-83. LAG VLAN Assignments CLI Commands
CLI Command Description
switchport mode {access | trunk
| general
}
Configures a LAG VLAN membership mode.
switchport trunk native vlan
vlan-id
Defines the port as a member of the specified
VLAN, and the VLAN ID as the LAG default
VLAN ID (PVID).
switchport general pvid
vlan-id
Configure the LAG VLAN ID (PVID) when the
interface is in general mode.