Filter
Top Products
338 Configuring Routing
www.dell.com | support.dell.com
3
Define the fields.
See "Configuring VRRP" for information about the fields.
NOTE: VRRP interfaces must be defined before the admin state can be Enabled.
4
Click
Apply Changes
.
The new VRRP interface is added, and the device is updated.
NOTE: If an illegal virtual IP address is entered, a warning will display, but the virtual router will be
added. It is recommended that you delete this entry from the virtual routers table.
Modifying VRRP Routers
1
Open the
Virtual Router Redundancy Protocol (VRRP)
page
.
2
Select an interface in the
Interface
field.
3
Define the fields as desired.
4
Click
Apply Changes
.
Deleting a VRRP Entry
1
Open the
Virtual Router Redundancy Protocol (VRRP)
page
.
2
Click
Show All
to display the
VRRP Table
.
3
Select a table entry.
4
Check the
Remove
check box.
5
Click
Apply Changes
.
The VRRP entry is deleted, and the device is updated.
Configuring VRRP Using the CLI Commands
The following table contains the CLI commands for configuring the VRRP.
Table 8-3. VRRP CLI Commands
CLI Command Description
vrrp
virtual-router ip
ip-address
[
ip-
address2…ip-address8
]
Defines Virtual Router Redundancy Protocol
(VRRP) for an interface.
vrrp
virtual-router
up Activates Virtual Router Redundancy Protocol
(VRRP) on an interface.
vrrp
virtual-router
timer
seconds
Configures the time interval between sending
advertisements messages.
vrrp
virtual-router
priority
priority
Configures Virtual Router Redundancy
Protocol (VRRP) priority on an interface.