Filter
Top Products
Configuring Quality of Service 461
The following is an example of the CLI commands:
console(config)# policy map policy1
console(config-pmap)# class class1 access-group dell
console(config-pmap)# trust cos
console(config-pmap)# set dscp 56
console(config-pmap)# police 124000 96000 exceed-action drop
console(config-pmap)# exit
console(config)# qos aggregate-policer policer1 124000 96000
exceed-action drop
Applying Policies to Interfaces
Use the
QoS Policy Binding
page to implement policies on interfaces. To open the page, click
Quality of Service
→
Advanced QoS Mode
→
Policy Binding
in the tree view.
class
class-map-name
[access-group
acl-name
]
Defines the traffic classification, and
enters policy map class configuration
mode.
trust [cos | dscp |
tcp-udp-port]
Configures the trust state, which selects
the value that QoS uses as the source of
internal DSCP value.
set {dscp
new-dscp
|
queue
queue-id
| cos
new-cos
}
Sets new values in the IP packet. Note:
This command is mutually exclusive of
the trust command.
police
committed-rate-
bps committed-burst-
byte
[exceed-action
{drop | policed-dscp-
transmit}]
Defines a single policer for classified
traffic.
qos aggregate-policer
aggregate-policer-name
committed-rate-bps
excess-burst-byte
exceed-action {drop |
policed-dscp-transmit}
Defines the police parameters that can be
applied to multiple traffic classes within
the same policy map.
Table 10-15. Policy CLI Commands
CLI Command Description