Filter
Top Products
1. Follow the procedures in "Before You Begin."
2. Install the TAPI-compliant sound card.
3. Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the microphone, speaker/headphone, or line-
in connectors on the front or back panel of your computer.
4. Connect the 4-pin TAPI cable to the TAPI sound card connector.
To locate the TAPI connector on the sound card, see the manufacturer's documentation.
5. Connect the other end of the cable to the TAPI connector on the modem card.
To locate the TAPI connector on the card, see the manufacturer's documentation.
6. Close the computer cover.
7. Attach the computer stand, if it is used.
8. Reconnect the computer and devices to electrical outlets, and turn them on.
If enabled, the chassis intrusion detector causes the following message to appear on the screen at the next computer start-up:
ALERT! Cover was previously removed.
9. Reset the chassis intrusion detector by changing Chassis Intrusion to Enabled or Enabled-Silent.
10. Enter system setup, click Integrated Devices, and change the setting for Sound to Off.
11. Install the appropriate drivers for the new devices.
For more information, see the manufacturer's documentation and your Windows documentation.
Back to Contents Page
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.