Filter
Top Products
To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated.
System Board Jumper Settings
LegacySelect Technology Control
LegacySelect technology control offers legacy-full, legacy-reduced, or legacy-free solutions based on common platforms, hard-drive images, and help desk
procedures.Controlisprovidedtotheadministratorthroughsystemsetup,DellOpenManage™ITAssistant,orDell™custompreinstalledintegration.
LegacySelect allows administrators to electronically activate or deactivate connectors and media devices that include serial and USB connectors, a parallel
connector, a floppy drive, PCI slots, and PS/2 connectors. Connectors and media devices that are deactivated make resources available. You must restart the
computer to effect the changes.
Manageability
Alert Standard Format
ASF is a DMTF management standard that specifies "pre-operating system" or "operating system-absent" alerting techniques. It is designed to generate an
alert on potential security and fault conditions when the operating system is in a sleep state or the system is powered down. ASF is designed to supersede
previous operating system-absent alerting technologies.
The OptiPlex GX60 supports the following ASF version 1.0 alerts and remote capabilities:
NOTICE: Ensure that your computer is turned off and unplugged before you change the jumper settings. Otherwise, damage to your computer or
unpredictable results can occur.
Jumper
Setting
Description
PSWD
(green jumper)
(default)
Password features are enabled.
Password features are disabled.
RTCRST
Real-time clock reset
jumpered unjumpered
Alert
Description