Filter
Top Products
Back to Contents Page
Power Supply
Dell™OptiPlex™GX60SystemsUser'sGuide
Removing the Power Supply
Replacing the Power Supply
DC Power Connectors
Removing the Power Supply
Small Form-Factor Computer
1. Follow the procedures in "Before You Begin."
2. Disconnect the DC power cables from the system board and the drives.
Note the routing of the DC power cables underneath the tabs in the computer frame as you remove them from the system board and drives. You must
route these cables properly when you replace them to prevent their being pinched or crimped.
3. Press the release button located on the floor of the computer frame.
4. Slide the power supply toward the front of the computer approximately 1 inch.
5. Lift the power supply up and out of the computer.
Small Desktop Computer
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions.
1
release button
2
AC power connector