Filter
Top Products
138 Removing and Installing Parts
8
If you are not replacing the drive, replace the drive-panel insert (see
"Replacing the Drive-Panel Insert" on page 126).
9
Replace the drive panel (see "Replacing the Drive Panel" on page 127).
10
Replace the computer cover (see "Replacing the Computer Cover" on
page 172.
11
If you are not replacing the drive, then ensure that these changes are
reflected in the BIOS. When you restart your computer, enter system
setup (see "System Setup" on page 178). On the setup screen go to the
"Drives" section and under
Diskette Drive
set the value to "
none"
.
Installing a Floppy Drive
1
Follow the procedures in "Before You Begin" on page 99.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 101).
3
Lay the computer on its side so that the system board is on the bottom of
the inside of the computer.
4
Remove the drive panel (see "Removing the Drive Panel" on page 124).
5
If installing a new floppy drive, remove the drive panel insert (see
"Removing the Drive-Panel Insert" on page 125).
6
If you are installing a new floppy drive, remove the shoulder screws from
the inside of the drive-panel insert and attach the screws to the new drive.
See "Removing the Drive-Panel Insert" on page 125.
1 floppy drive 2 shoulder screws (4)
1
2
book.book Page 138 Tuesday, November 27, 2007 10:29 AM