Filter
Top Products
Removing and Installing Parts 125
6
Replace the drive panel (see "Replacing the Drive Panel" on page 114).
7
Replace the computer cover (see "Replacing the Computer Cover" on page 159).
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
8
Connect the computer and devices to electrical outlets, and turn them on.
Installing an Optical Drive
1
Follow the procedures in "Before You Begin" on page 85.
2
Remove the computer cover (see "Removing the Computer Cover" on page 86).
3
Remove the drive panel (see "Removing the Drive Panel" on page 113).
4
Remove the existing optical drive, if applicable (see "Removing an Optical Drive" on page 123).
5
Prepare the optical drive for installation and check the documentation that accompanied the drive to
verify that the drive is configured for your computer.
NOTE: If you are installing an IDE drive, configure the drive for the cable select setting.
1 drive release latch 2 optical drive
1
2