Filter
Top Products
Delta DOP Series HMI Connection Manual|DOP-A/AE/AS Series
1-42 Revision January, 2008, Doc. Name: 2007PDD23000007
Jetter JC Series PLC Back to Table
A. HMI factory settings
Baud rate: 9600, 8, EVEN, 1 (RS-232).
Controller station number: 0. (no PLC station number in protocol, therefore, only 1(HMI) to 1 (PLC)
communication is allowed.)
Control area/status area: WR0 / WR10.
NOTE
1) Please notice that no PLC station number in protocol, therefore, only 1(HMI) to 1 (PLC) communication
is allowed.
2) Only 1 Bit or 1 Word / 2 Words can be transferred for each read and write command.
B. Definition of controller Read/Write address
Registers
Read/Write Range
Register Type Format
Word No. Bit No.
Data
Length
16 Bits Register WRn n: 0 ~ 32767 N/A 16 Bits
32 Bits Register Rn n: 0 ~ 32767 N/A 24 Bits
The characteristics of WRn and Rn of JC series are the same as the Nano series. Please refer to the section
that introduces Jetter Nano Series PLC
.
Contacts
Read/Write Range
Contact type Format
Word No. Bit No.
Input Relay Inbb n: 1 ~ 32 bb: 01 ~ 16
Output Relay Onbb n: 1 ~ 32 bb: 01 ~ 16
Flag Relay Fn N/A n: 0 ~ 32767