Filter
Top Products
Starting and Configuring the Device
Startup Procedures
Page 43
Startup Procedures
This section includes the following topics:
• Startup Menu Procedures
• Software Download and Reboot
Startup Menu Procedures
The procedures called from the Startup menu cover software download, flash handling, and password recovery.
The diagnostics procedures are for use by technical support personnel only and are not disclosed in this
document.
The Startup menu can be entered when booting the device. A user input must be entered immediately after the
POST test.
To enter the Startup menu:
1. Turn the power on and watch for the auto-boot message.
This command will reset the whole system and disconnect your current
session. Do you want to continue (y/n) [n] ?
y
**************************************************
***************** SYSTEM RESET *****************
**************************************************
------ Performing the Power-On Self Test (POST) ------
UART Channel Loopback Test............PASS
Testing the System SDRAM.............PASS
I2C Bus Test.........................PASS
Boot1 Checksum Test................PASS
Boot2 Checksum Test................PASS
Flash Image Validation Test............PASS
BOOT Software Version 1.0.0.11 Built 10-Apr-2005 13:25:46
DES3010 D-LINK board - based on Samsung S3C2510A ARM940T processor.
32 MByte SDRAM. I-Cache 4 KB. D-Cache 4 KB. Cache Enabled
.
Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
2. When the auto-boot message appears, press <Enter> to display the Startup menu. The Startup menu
procedures can be done using the ASCII terminal or Windows HyperTerminal.
[1] Download Software
[2] Erase Flash File
[3] Erase Flash Sectors
[4] Password Recovery Procedure
[5] Enter Diagnostic Mode
[6] Back
Enter your choice or press 'ESC' to exit:Enter your choice or press 'ESC' to exit:
The following sections describe the available Startup menu options.