Filter
Top Products
D-Link DIV-140 User Guide 15
Call Configuration
Timeout:
Dial Timeout:
Connection Timeout:
Alerting Timeout:
Interdigit Timeout:
Interdigit Time
while Dialing:
FXO Rings:
Dial Termination:
Character Termination:
Various constants which are used during the call setup (like
maximum timeout or number of rings) can be configured in this
section.
Enter the maximum time to wait for a user to dial any key after
going off hook. After this timeout is reached an error tone
is played to the user. Range: 5 to 120 seconds. Default: 15
seconds.
Enter the maximum time to wait to get any response from the
other end. During this period a progress tone is played and
after the timeout limit is reached an error tone is played to the
user. Range: 5 to 180 seconds. Default: 45 seconds.
Enter the maximum time to play a ring back tone for outgoing
calls when the called party starts ringing. For incoming calls
this field defines how long the phone will ring when user doesn’t
answer. Range: 5 to 120 seconds. Default: 60 seconds.
Enter the maximum time to wait in between digits while dialing
the number. After this timeout, further digits are ignored and
the collected digits will be dialed out. Range: 1 to 120 seconds.
Default: 5 seconds.
Enter the time between digits while dialing out the received number on FXO line using DTMF tones. Range: 50 to 1000 milliseconds. Default: 300
milliseconds.
Enter the number of rings to wait before going off hook on FXO port when the FXO port is ringing. Range: 1 to 9 rings. Default: 2.
Note: If this field is configured as 1 then caller ID detection on the FXO port won’t work.
Here you can configure if any special DTMF key like * or # to use for terminating the dialed number while placing outgoing call. Note that Inter
Digit timeout will be always active.
Select enable if you want to terminate the dialed number using a DTMF key, otherwise select Disable. Default: Enable.
If character termination is enabled then you can also terminate the feature access keys with this.