Filter
Top Products
D-Link DIV-140 User Guide 21
VoIP Configuration
Server Settings:
Primary Server
Address:
Port:
Secondary Server:
Port:
Registration Timeout:
Uri Scheme:
Transport:
Use Same
Authentication for
All Channels:
Phone Number:
Display Name:
Authentication User ID:
The SIP Server specific parameters are configured here. If
there is no SIP server being used then the fields in this section
can be left empty.
Enter the IP address or domain name of the primary SIP server.
Default: www.sipproxy1.com.
Enter the primary SIP server port in this field. Default: 5060.
Enter the IP address or domain name of secondary SIP
server. This is used as backup in case if primary server is not
reachable. Default: www.sipproxy2.com.
Enter the secondary SIP server port in this field. Default:
5060.
This specifies the interval at which the registration should be
updated with server. Range: 40 to 2000000 seconds. Default:
3600 seconds.
Note: When STUN is enabled this field should be set to a value
smaller than the binding inactivity timeout on the NAT/Router.
This way the binding for SIP local port will be kept alive.
This feature will be supported in future releases.
This feature will be supported in future releases.
Enable this to use the same authentication parameters specified
in this section for all ports. Enabling this setting will disable all authentication fields on the Port Configuration > General page. Default: Disable.
This specifies the phone number using which other devices can call this device. This field accepts only numbers and can be a maximum of 20
characters.
This is used only for display purposes. This field accepts only letters, digits, hyphen and underscore and can be a maximum of 30 characters.
Used to authenticate the device with a SIP server. This field accepts only letters, digits, hyphen and underscore and can be a maximum of 30
characters.