Filter
Top Products
40 Chapter 5 Operating SCU
ACTURA Flex 48330 Power System User Manual
5. At any rectifier information page, press “ESC” repeatedly and you can return to
the higher-level menus.
5.5 Querying Alarms And Setting Alarm Plans
The monitoring module can locate and record the system fault according to the
collected data, as well as raise audible/visual alarms and output through dry
contact according to the preset alarm level. Meanwhile, it reports the alarms to the
host.
You can query historical alarms and active alarms through the LCD of the
monitoring module.
5.5.1 Querying Active Alarm
When a new alarm is raised, and there is no operation on monitoring module
keypad within 2 minutes, the LCD of the monitoring module will prompt
automatically the active alarm.
If there are multiple alarms in the current system, you can query alarms through the
following steps:
1. At any system information page, press “ENT” to enter the main menu
2. Use “
” or “” to select the “Status” submenu in the main menu and press
“ENT” to confirm.
Status
Rectifiers
Active Alarm
Alarm History
3. Press “
” or “” to select the “Active Alarm”, as shown in the above figure, and
press “ENT” to confirm.
1) If there is no active alarm, “Active Alarm: None” will be displayed
Active Alarm!
None