Filter
Top Products
68 Chapter 5 Operating SCU
ACTURA Flex 48330 Power System User Manual
Table 5-18 Value description of system settings
Parameter Range Default Value description
Text
Chinese, English and
Spanish
Chinese Set according to your need
Address 1 ~ 254
The addresses of power systems that are at the
same monitored office should be different
CommMode
modem, EEM-M,
RS-232
“MODEM”: Through modem and based on the
Telecom protocol.
“EEM-M”: Through modem and based on the EES
protocol.
“RS-232”: Through a transparent serial port and
based on the Telecom protocol
BaudRate
1200bps, 2400bps,
4800bps, 9600bps
Make sure the baud rates of both the sending and
receiving parties are the same
CallBack
Num.
1 ~ 10 3
When
“CommMode
” is set to
“MODEM” or
“EEM-M”
CallBack
Number
19 digits at most
Set according to the actual need. In a extension
system, sometimes you need to put a “,” between the
main number and extension number. When the
callback number is less than 19 digits, end it with a
“#”
Set Date 2,000 ~ 2,099
Set Time Hour, min, sec
Set the time according to the current actual time,
regardless of whether it is a leap year or not
Initialize
password
Y, N N
Selecting “Y” can reset the user level and
administrator level passwords to the defaults
Operator
level or
above
Init Param
(Initialize
parameter
s)
Y, N N
When the system parameters cannot be set normally,
and the usual resetting methods do not work, you
can set the “Init Param” to Y, and all the system
parameters will be restored to defaults. Alarms may
be raised for the defaults may fail to meet the actual
situation. Set the parameters according to the actual
situation then.