Filter
Top Products
Chapter 5 Operating SCU 53
ACTURA Flex 48330 Power System User Manual
The maintenance operations over a single rectifier include: “DC ON/OFF”, “AC
ON/OFF” and “Reset”. The operation method is:
① Use “
” or ”” to select the rectifier parameter, and “” or “” to change the
rectifier serial No. Then press “ENT” to confirm. The bottom line of the page
displays the rectifier ID.
② Use “
” or “” to move the cursor to the maintenance operation area, and
“
” or “” to select the value.
If the rectifier voltage is too high, you can select “Reset” to restore the output
voltage of that rectifier to normal.
6. There will be prompts as the confirmation of control commands. If the
maintenance operation is valid, system will prompt you press “ENT” to confirm and
execute the operation, or “ESC” to abort the operation. Otherwise, system will
prompt you the operation is invalid, and press “ESC” to quit.
Press ENT to Run
Other Key Quit
No Maintain!
ESC Quit
Press “ESC” to return to the menu of higher level.
5.7 Setting System Parameters
Battery parameters are very important, for they are related to the life of battery.
Before delivery, the battery parameters have been initialized. Without any special
needs, you only need to reset the battery group number and battery capacity, and
accept the defaults for other parameters.
5.7.1 Parameter Setting Method
1. At any system information page, press “ENT” to enter the main menu.
MAIN MENU
status
Maintenance
Settings