Filter
Top Products
1-28
28 | Setting Up the Printer
Accessories:
Assembling the Stand
1. Insert the support bar into one of the base sections as shown. Then
attach it with two bolts (H) using the included Allen wrench. (Leave the
bolts a little loose, so that you can adjust the position when you insert
the bolts at the other end.)
2. Attach the base section to the other end.
3. Tighten all four bolts securely.
G: Allen wrench
H: Bolts (4)
I: Wing nuts, spring washers, and plain washers (2)
J: Paper supports (5)
H
G
I
J
H